-40%
DIY Transformer Education Kit

DIY Transformer Education Kit

$ 16.86

Availability: 80 in stock
  • MPN: CJKIT-20312
  • All returns accepted: Returns Accepted
  • Item must be returned within: 30 Days
  • Restocking Fee: No
  • Condition: New
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Type: electronic kit
  • Return shipping will be paid by: Buyer
  • Brand: Jameco Kitpro

    Description

    Build Your Own Transformer Kit
    Learn how to wind your very own
    step-up transformer
    coil from scratch with this simple kit. Great for anyone from a beginner to the most advanced builder. After all, it's great to be able to say you made something from a handful of parts. It's something more to say you made the parts too.
    The Club Jameco transformer project listed below is a basic and simple educational kit demonstrating how to build your own transformer. The project below was designed as a starting point to give you a basic core experience that you could work and experiment with. Please note that the design will vary dependent on an individual's design requirements.
    Please share your comments and suggestions at The Power Transformer Kit design page, and check out what others are saying about the DIY Transformer project build!
    Read Jameco's Transformer Electronics Fundamentals page.
    WARNING:
    If you are unsure of the dangers involved with your particular project, consult with someone who is experienced. Always wear eye protection and gloves. FAILURE TO INITIATE AND FOLLOW YOUR OWN SAFETY PROCEDURES MAY RESULT IN BODILY INJURY OR DEATH!
    THE TRANSFORMER SHOULD NEVER BE CONNECTED DIRECTLY TO AC MAINS VOLTAGE. A 120 VAC @ 350mA (OR LESS) AC/AC ADAPTER IS ADVISED FOR THIS LEARNING TASK.
    Note:
    The order in which you wind the primary and secondary coils does not matter as long as the windings ratio is the same in the end. If you would like to build a
    step-down transformer
    , you would need to have more turns on the primary coil than the secondary coil (opposite of step up).
    You Will Need:
    120V AC/AC 350mA (or less) wall adapter (optional, for testing)
    Soldering iron
    Solder
    Calculator
    Electrical tape
    Transformer Kit Includes:
    Part No.
    Qty.
    Description
    2119347
    2
    Magnet Wire, 26 AWG, 1/4 lb (328 ft.)
    2098398
    1
    Magnet Wire, 20 AWG, 1/4 lb (81 ft.)
    2160657
    1
    Transformer Bobbin, Horizontal Mount
    2160665
    2
    Ferrite E Core, Ungapped
    ---
    1
    Instructions
    Club Jameco Project #20312
    Check out more fun and exciting electronic projects